American-expedition-vehicles JK WINCH MOUNT Bedienungsanleitung PDF herunterladen

JK WINCH MOUNT

Installation Guide – AEV30111AC

(Updated 07/2/2013)

Page 1 of 10

1 2 3 4 5 6 7 8 9 10

JK WINCH MOUNT Installation Guide – AEV30111AC (Updated 07/2/2013) Page 1 of 10

IMPORTANT NOTE: When installing the Winch you MUST use the AEV supplied washers along WITH the hardware included with your winch kit (as shown.) This

This page left intentionally blank Page 2 of 10

PLEASE READ BEFORE YOU START IN ORDER TO INSTALL THIS PART PROPERLY YOU OR YOUR INSTALLER MUST READ THESE INSTRUCTIONS THOROUGHLY BEFORE BEGINNING TH

Seite 5

A. INSTALLATION 1. You will need to remove the front bumper and fairlead bracket from the vehicle if previously installed 2. Start with removing the

Seite 6

helpful to hold them in place. 6. Place the winch onto the winch mount. Do not install winch mounting bolts at this time. You will do this later af

Seite 7

C. WINCH PLATE INSTALLATION - 2012 AND NEWER 1. Remove and save the 2 M6 nuts and lift the vacuum pump off the factory bracket. 2. Assembl

Seite 8

3. Drill out the lower mounting hole to 1/2" as shown to allow the bolt to pass through. 4. Depending on the winch being installed yo

Seite 9

Page 8 of 10

5. Assemble the winch plate and fairlead brackets together. Use the M12 hex head bolts and flange nuts going from the bottom up(washer not needed) a

Keine Kommentare

American-expedition-vehicles JK WINCH MOUNT Bedienungsanleitung