American-expedition-vehicles JK HEMI Builder Kit - Installation Guide for 12+ J Bedienungsanleitung PDF herunterladen (Seite 36)

axle ratio programming

Using the ProCal Module to program axle ratio once your new HEMI engine is installed requires a special

mode. Programming axle ratio is required after completeing your HEMI conversion even if you did not

change your axle gear ratio. There is no performance increase by adjusting this value to anything besides

what the vehicle has physically installed. Failure to program the axle gear ratio or programming the incor-

rect ratio will cause some vehicles to go into “Limp-In” mode.

1. Set the rst 3 DIP switches as shown.

2. Set switches 4 and 5 as shown.

5.7 L 6.4 L

3. Set the remaining switches based on the chart. Once all the dip switches are set, please refer to the

User Guide that came with your ProCal Module for the proper programming procedure.

tire size programming

You may now use the ProCal Module to program your tire size. Please use the Quick Reference Guide and

User Guide that came with your ProCal Module for the proper programming procedure.

1 2 ... 31 32 33 34 35 36 37

Keine Kommentare

American-expedition-vehicles JK HEMI Builder Kit - Installation Guide for 12+ J Bedienungsanleitung Seite 36